(click to enlarge) Even though I find Myir’s Z-Turn Lite + its IO Cape combination of cards useful and well designed, there’s a small and annoying detail about them: The spacers that arrive with the boards don’t allow setting them up steadily on a flat surface, because the Z-Turn board is elevated over the IO [...]
As I use Blender only occasionally, I’ve written down quite a few hints to myself for getting back to business. If this helps anyone else, so much better. I’ve also written two similar posts on this matter: A general post on Blender and a post on rendering and animation. Printing methods See a summary chart [...]
As I use Blender only occasionally, I’ve written down quite a few hints to myself for getting back to business. If this helps anyone else, so much better. I’ve also written two similar posts on this matter: A general post on Blender and a post on 3D printing. Bones For a simple beginner’s use example, [...]
As I use Blender only occasionally, I’ve written down quite a few hints to myself for getting back to business. If this helps anyone else, so much better. Except when said otherwise, the notes here relate to version 2.79b (which is a different interface than what is common today). I’ve also written two similar posts [...]